Application
Use at 7L per ha and check the required rate in the calculator below.
This calculator will help you select how much product to mix with how the right amount of water:
Calculator
Pots
Quick Application Guide
- Start the irrigation system and allow it to run for approximately 15 minutes before introducing AquaBoost.
- Add AquaBoost into the irrigation system at a rate of 7 litres per hectare. If necessary, use the AquaBoost Calculator above for assistance.
- After the AquaBoost has been applied, continue the irrigation cycle to ensure the product is washed into the soil.
Application Guide
- When applying AquaBoost, run the irrigation system for around 15 minutes beforehand to prime the lines and lightly wet the soil.
- Apply AquaBoost twice at a rate of 3.5 L per hectare, spacing the applications 4–5 days apart.
- Each application should be applied with at least 7mm of irrigation water (70,000 L per hectare) for centre pivots, and 3–4mm of water when using drip or micro-sprayer systems. After this, the irrigation volume can be reduced. This amount of water helps move the AquaBoost into the soil where it can be effective.
- If a mixing tank is used, do not combine AquaBoost with water and fertilizer. It should be mixed only with water in the tank. The tank does not need to be cleaned beforehand provided it has previously been flushed at least once with clean water.
- Apply fertilizer immediately after the second AquaBoost application to achieve the best fertilizer performance.
FAQ's
AquaBoostAG is a liquid and can be applied via any irrigation system in the same manners as liquid fertilisers.
Add AquaBoostAG into the irrigation system via your fertigation unit with water or via a dosing pump.
It is suitable for:
- Drip irrigation
- Centre pivot irrigation
- Boom spray
- Overhead / low throw sprinklers
- Flood furrow irrigation
- Sub-surface drip and tape
